Generic selectors
Exact matches only
Search in title
Search in content
Post Type Selectors

ZEFS BSC3i

Viewing 13 posts - 1 through 13 (of 13 total)
  • Author
    Posts
  • #45658
    TOMAR
    Guest

    THIS IS WITH REFERENCE TO NOKIA BSC3i.

    ZEEI:BCF;

    ADMN STATE OP STATE

    WHAT IS THE DIFFERNCE BETWEEN ABOVE STATES.

    #45659
    TOMAR
    Guest

    In case the status of OMU for the ultrasite is OMU-BL:
    ZEFS:….;
    Shows that the BTS O&M link is out of order.

    In case the status of OMU for the ultrasite is OMU-WO:
    ZEFS:….;
    The command is successfully executed.

    #45660
    TOMAR
    Guest

    Now if the OMU is BL that maens you cannot access the BTS from BSC. But even in the case of OMU-BL if we want to lock the BTS through the ZEFS command, the message appears that BTS O&M link is out of order. This means our command is not executed by the BSC. But if you see through ZEEI the status of all BTS/TRX is shown BL-USR. But the reverse is not true.That is you cannot unlock the BTS if OMU-BL.

    #45661
    TOMAR
    Guest

    The difference which i observed for the ZEFS command for case when:
    OMU-BL:
    ADMN STATE OP STATE
    U BL-USR

    OMU-WO:
    ADMN STATE OP STATE
    L BL-USR

    what is the difference between ADMN STATE and OP STATE ?

    #45662
    MANOJ
    Guest

    no experts comments.
    people here just wants ebooks…….

    #45663
    Alex263
    Guest

    ADMN STATE means set by operator, OP STATE refers to hardware/sw fault etc

    #45664
    eduardo
    Guest

    hi, i am now the commands but i want found material or book´s about this to created and modified base station for gsm nokia

    #45665
    Miguel
    Guest

    About the ZEEI:BCF command, ADM STA is the condition you can control, that is locked or unlocked and OP STATE is the answer of the equipment, example: you unlock the trx and if all is ok the OP STATE is WO, but if the TRX fails, it can be BL-TRX
    Regards

    #45666
    Ankit
    Guest

    This is the regerence to Nokia BSC3I

    ZEQM;
    THIS COMMAND IS USED FOR ENABLING AND DISABLING THE ANTENNA HOPING MODE OF A ANTENNA.

    #45667
    CHIRAG PATEL
    Guest

    I WANNA TCSM RELATED COMMAND.PLS SEND ME .

    #45668
    Abir
    Guest

    What is the command to check rssi for any site from bsc 3i?

    #45669
    Davinder Singh
    Guest

    what if i have to change the polarity of alarm

    #45670
    devesh chandra
    Guest

    plz sand me mml command

Viewing 13 posts - 1 through 13 (of 13 total)
  • The forum ‘Telecom Design’ is closed to new topics and replies.