Generic selectors
Exact matches only
Search in title
Search in content
Post Type Selectors

SD Drop reason

Viewing 14 posts - 1 through 14 (of 14 total)
  • Author
    Posts
  • #45097
    Optimizer
    Guest

    Hi,
    Does anybody has idea about SDCCH drop reason “Suddenly Drops Coneection”. What could be the reason of Suddenly drop connection?

    #45098
    Vanderlay
    Guest

    Which vendor equipment is this?

    #45099
    Anoop
    Guest

    hi all,
    Pls snd me details in one bye one as SDCCH Drop, Block, TCH Drop, Block, SDCCH Congestion, TCH congestion and CSR, all reason requried in only GSM, CSSR.,,,,,,,,,, Waiting ur response all

    #45100
    Simanullang
    Guest

    “SDCCH drop due to Suddenly drops connection” this will happen if subscriber get into lift or basement so signal will suddenly dropped –> sdcch/tch drop. please audit direction of antenna and adjust it.

    #45101
    King
    Guest

    HI
    My network suffering form TCHDR in some cells, I want for you more information to process that and what the Parameters affection for this issue
    thanks
    BR
    King

    #45102
    pankaj kalyani
    Guest

    hi all,
    can u pls tell me abt sd,tch drop & congestion causes as well as and steps required to minimize these…..waiting 4 ur response

    #45103
    pankaj kalyani
    Guest

    hi pix,
    i want to know direct retry,cell load sharing parameters of nokia system

    #45104
    Manu katyal
    Guest

    DR i.e Direct retry is a feature in Nokia System.

    With DR enabled if SD is allocated & all the TCH are busy then TCH is allocated from a different cell(neighboring cell).
    As far as cell loading parameters is concerned there is a very good feature in Nokia Sys i.e TRHO
    (Traffic Reason Handover) with this paramter enabled u can offload ur highly congested cells bt be aware of TGT value else there will be ping-pong handoveres.

    #45105
    Prabhakar Kumar
    Guest

    PSR-Paging Success Rate,
    CSSSR- Call SetUP Success Rate,
    SD Drop,
    TCH Drop,
    SD Congestion,
    TCH Congestion,
    SD Block,
    TCH Block,

    All Reasons & rectification done by rf issue.;;;

    Waitting ue response early..

    #45106
    ARIF
    Guest

    Main factors causing high SDCCH Drop rate are as follows:

    (I) Inappropriate parameter configuration (system information)
    (II) Inadequate system capacity

    Solutions:

    (1) Parameter modification (threshold of random access error, RACH access threshold),maximum times for retransmission, the number of TS in transmission expansion.

    (2) Attention to parameter configuration for partition of location area and location renewal update (configuration for 1800MHz dual band network, CRO, cell reselection hysteresis parameters, time for periodic location etc.,)

    (3) In Dual band networks, an exceedingly high rate of excessive location renewal update may be caused by an exceedingly high rate of excessive handover between mobile switch offices centers. Modification shall be made to handover parameters of the 1800MHz dual network, CRO, etc

    (4) Apart from factors mentioned above, there might be capacity problems. SDCCH configuration number shall be increased or dynamic SDCCH assignment function and TCH carrier shall be engaged.

    #45107
    Aniii
    Guest

    Hi ,Everyone I am working on Huawei system, Can anybody what is the diff b/w TCH Drop and SD Drop $ TCH Blocking and SD Blocking.

    #45108
    das
    Guest

    PSR drop reason

    #45109
    abhishek
    Guest

    hi all,

    pls send me reason for SD drop,tch drop ,tch assignment.

    #45110
    Maya
    Guest

    can a transcoder misconfiguration cause SD drops, or does it only cause drops on TCH? thanks

Viewing 14 posts - 1 through 14 (of 14 total)
  • The forum ‘Telecom Design’ is closed to new topics and replies.