Generic selectors
Exact matches only
Search in title
Search in content
Post Type Selectors

AMR

Viewing 12 posts - 1 through 12 (of 12 total)
  • Author
    Posts
  • #44122
    More
    Guest

    Hi guys has anyone of you implemented AMR(Adaptive multi Rate)?.I’m trying to implement this feature both BSS and MSC are Siemens, we have a problem to have this feature work from the MSC side. any experience will be appriciated…

    #44123
    hari
    Guest

    v hav successfully implemented de feature in ericsson. elaborate ur problem,is it amr-hr or fr

    #44124
    pipes
    Guest

    Hari,
    We are thinking to implement AMR in our network, while moving smoothly to ericsson softswitch. We’d like to integrate 3 ericsson MGWs in a ring with AMR compression. From your experience how can this solution save transmission capacity?

    #44125
    tufial
    Guest

    hi guys

    iwant to know about v convert FR to HR. how 1 TS supports 2 subscribers. does it uses its basics bit for the other subs

    thanks in advance
    tufail
    tufial@gmail.com

    #44126
    hari
    Guest

    pipes,i dint get ur question. amr,coders basically, r placed at the edge,n this certainly reduces the tx cost

    #44127
    More
    Guest

    Hi Hari!

    My problem with our switch(Siemens) is that the switch guys are telling us that, the Same feature(circuit_Pooling) that is used for both HCSD and AMR was not released on the Siemens switch and they have to take down the switch to release this feature, apperantly the switch has to go to instalation mode first. From the BSS side I can not trial AMR if Pooling is not released from the switch. Is there anyone else who implemented this feature on Siemens?
    Thanks

    #44128
    sinko
    Guest

    Hi More,
    if you use TRAC v7 and Common Codec Pool feature then you don’t need MSC pooling

    #44129
    Bubu
    Guest

    It can be activated by Siemens patch without bringing down the switch.

    #44130
    More
    Guest

    Thanks guys!

    we have realeased the feature on the MSC side. now the problem is with configuring the pool. The Siemens switch is rejecting the first step that need to be done to change the trunk groups. The commands is: MOD CIR P PREF : SCIRPNO = POOL23(POOL27), ACIRPNO = NOPOOL;

    This must be done according to the MSC setup test case. Any suggestion?

    #44131
    Bubu
    Guest

    DISPMSERVOPT:FEAT=LTGPOOL; what is the status?

    #44132
    More
    Guest

    Hi Bubu;
    Here are the status:

    DISPMRPDDAT:MAXPFXCH=2;
    DISPMSERVOPT:FEAT=ALOWTCHF, STAT=ACT;
    DISPMSERVOPT:FEAT=LTGPOOL, STAT=ACT;

    how does it look?

    #44133
    More
    Guest

    Guys!

    we have been able implement AMR at last. But now we have another problem, after implementation we are having problem with LTG overload and this is only affecting LTG’s that are connetcted to the AMR TRAU. we are using POOL27 to avoid re-dimentioning in case we make very few AMR calls. does any body know why we are having this LTG overload? FYI only one PCMA from this TRAU goes to the same LTG.

    thanks;

Viewing 12 posts - 1 through 12 (of 12 total)
  • The forum ‘Telecom Design’ is closed to new topics and replies.