- This topic has 8 replies, 1 voice, and was last updated 14 years, 9 months ago by
pudu.
-
AuthorPosts
-
Lubos
GuestHallo, what are the differences ? Is possible to use Nortel radio from S8000 (NTQA01) in S12000?
t28
Guestwhat do you mean – ‘nortel radio’ ?
Lubos
GuestHallo t28,
I mean Nortel DRX part number NTQA01, sorry for wrong term.patrick
GuestI’m not sure to 100% but I intended to say that it is the same.
The really difference is with BTS S18000.
Tony
GuestWhat is the difference between the 18000 & 12000
Patrick
GuestS18000 => GSM, DCS, GPRS, EDGE and UMTS
S12000 => no UMTS
vimal
GuestHi all,
one of our BSS team installed a new BSC, i face this peculiar problem1. once a hard reset is given to the BSC, the BSC comes to service normally but i can’t make 2 calls simultaneously, only a single call is successfully established, if a second call made the call is put throu i get a single ring back tone and then the call gets released. this happens in all the BTS connected to that BSC
2. when CTP is used i get Call release message insted of connect acknowledge
iam attaching the CTP message for u r reference
NSD TRID MSC BSS/ MS/
SMLC LMU
BSSMAP: CM Service Accept
DTAP: 1 0 Call Proceeding
BSSMAP: —–> Assignment Request
BSSMAP: Disconnect
DTAP: 0 0 Release Complete
BSSMAP: —–> Clear Command
BSSMAP:DNM
GuestHi Vimal,
I experience it same in our network in Huawei. Right now we still don’t find any alternated solution. Sir Vimal can you give some tips about how you resolved this problem.
thanks
DNM
pudu
Guesthi vimal
how about a check on the 8KRM. -
AuthorPosts