- This topic has 158 replies, 1 voice, and was last updated 13 years, 8 months ago by
.
-
Posts
-
CAN ANY BODY TELL ME ABOUT BTS ALARM AND AND THIER CONNECTION
rabindra sir,
i got an alarm at a site ,
BTS operation degraded:RX level differ bet. main & diversity.i thought its the VSWR problem but i got reading 1.21&1.19 at main & divercity end respectively,
i changed the trx and tightend the SMA connectors,i changed the combiners too still i m having the same alarm .
can any one help me out?hi sairam,
pls check these: 1.parameter RDIV should be ON.
2.it might be possible only RX Cable swap from other sector.
3.check all cable inside the BTS one point to other, it may be swap.Reason:this alarm can come when diversity may go beyond 5 So any of the cable inside BTS Gt. swapped.
Rgds
yogesh_rfHi,This is babu.I was joined as a entry level position in installation and commisioning of gsm equipment.i want to know how about the future is this .please respond me.
Thanks & Regards
babuwhere can i get training to enter in this field. freshers are not taken directly
Azamat – 11 Jan 2007
“What might be the reason of 7715 CONTINUOUS RESTARTS OF BCF”
Because your BTS reset 3 or 4 times in less than 5 minutes.
I don’t remember exactly but too reset in little times.It is not a critical alarm. You can reset by ZEOR:bcf:n°alarm;
Thanks Patrick, the cause of continuous restarts was unstable voltage… 🙂
Guys,
what does this alarm indicates?
=>>TRX FAULTY:
There is disturbance in the serial DL bus or bus is broken.how can i troubleshoot this?
Many thanks
why we will use the rx diversity in the NOKIA BTS
thanks yogesh,
Jadee – 27 Jan 2007
Extract of NED =>
Fault reason: There is disturbance in the serial DL bus or bus is broken.
Instructions:
1. TSxx is not properly installed or is missing.
Install it properly.
2. TSxx is broken.
Replace it.any one can send me the steps for integeration of BTS with NOKIA SW.
hello sir, i am newly joined to telecom sector, working with commissing of bts, bypassing of E1,INTEGRATION OF SITES.
Please send me the details about the above parameters.Patrick – Feb 1,2007
Thank you so much for the suggestion.
I got another question.
Is the RRI of Metrosite, compatible to Ultrasite? Can u use that module directly to Ultrasite? By re-mapping it at Traffic Manager?
Many thanks.
Jadee – 8 Feb 2007
We don’t have RRI for ultrasite. We have FXC ET1/T1.
4 PCM in/out
On traffic manager
– Select unit (FXC or RRI)
– select interface (PCM 1 …4)
– place Tch, TRXsig, OMUsig, Edap, on your abis allocation for BTS.(Warning: Metrosite don’t work with hubmanager.)
