- This topic is empty.
-
Posts
-
If anyone requires the process for energy savings by pcm kindly get in touch.
hey stuart .i d like to know the procedure to install and verification of the rbs 2206 2207 thank´s from roberto e-mail semeraro222@hotmail.com
Hi stuart,
I like to know the basics of BTS installation of ericsson
Thanks for your help
hi stuart,
suppose i am expanding the site
with 4+5+6 configuration with two RBS 2206.PLS tell me the hardware configuration between two bts’s.with regards,
chandan debnathI was wondering how different the command structure is for GSm from the 882/884 equipment, also I do not have any experiance with the GSM D.T. do you know where I could find information on the command structure?
Thank you for your timeIS THERE SOMEONE THAT CAN HELP ME WITH THE BASIC SETUP OF THE RBS200, I AM STUDYING COMMUNICATION TECHNOLOGY AND DOING THE RBS200 AS A PROJECT
Good Mooring
How to connct this configurtion 10/8/6
in RBS2206.please help my
i eargurly want to be informed about ERICSSON RBS 2106 configurations
Hello
I like to know the configution and maintenance
for rbs 2207 and 2206Hi al noumani
Its not possible as you can use 12/6/6 confg.only at max using 2 RBS 2206..If anyone knows about this then do reply.
Regards
Geet Mukhra
Hi chandan debnath
Use two cells in first RBS 2206 with tie values 0,1,2,3,4,5 in cell A and 6,7,8,9,10,11 in cell B.
Use third cell in second RBS 2206 at tie value 0,1,2,3,4,5.
You will require 9 DTRUs in all.
Now just defined the required tie values from OMCR as per you configuration.
As per your requirment following tie values will be used..
cell A 0,1,2,3
cell B 6,7,8,9,10
cell C 0,1,2,3,4,5Regards
Geet MukhraHi Noumani,
you can achieve the 10/8/6 config with three 2206 cabinet ;
cabinet 1 will take care of the sector with 10trxs and a cdu-f combiner will be ideal, the IDB will be configured for 1*12 but ties 10&11 will be deactivated
Cabinet 2 will take care of the sector with 8trxs again cdu-f combiner is used and the IDB is configured for 8+4 only the first two combiners will be used hence ties 8,9,10,11 is deactivated
Cabinet 3 will take care of the sector will 6trxs likewise cdu-f is used but the IDB is defined for 2*6 or still 8+4 and the used tie positions deactivated.You can refer to me further clarificationsbr.
MichaelHello All.
Please,If anyone have information or help with the hardware and fault finding side of Ericssons RBS200, 2000 & 2206 series of BTS’s. i hope to to hear from u soon.
thx allHi stuart,
I like to know the basics of BTS installation of ericsson, motorola….
Could you pls tell me how much is the power consumption of RBS2206? How much is heat dissipation of RBS2206?
and if have information or help with the hardware and fault finding side of Ericssons RBS200, 2000 & 2206 series of BTS’s.i hope to to hear from u soon.
thanks and regards
misHai
what is the difference b/w combinders CDU C,D,J and G…
one Ericsson Radio at a time can carries how many E1…
