Generic selectors
Exact matches only
Search in title
Search in content
Post Type Selectors

help: alarm on NOKIA ET

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #40728
    Patrick
    Guest

    Hi,
    I am french, sorry but my english is not very good. I read a lot of post of this forum and i can see that tere are many experts of BSS.

    I have an alarm on NOKIA’s ET
    BCSU-8
    * ALARM ET-83
    1B120-25 ERDSUP
    2990 V3 INTERFACE ALARM
    ET 83d 05

    What does it means. I see on NED but I don’t know to resolve.
    This alarm came after to make a new BTS on this ET.
    I have ET2E-S and BTS ultrasite connected. The PCM is correct signal.

    thank you for your help.

    #40729
    patrick
    Guest

    I found my problem.

    In supervision menu,

    ZYEI:ET,x;
    To see ET measurement configuration.

    ZYEC:ET:…
    To change ET configuration measurement.

    #40730
    Mohammad Yasin
    Guest

    Hi Patrick
    Can you explain a little more on what you have done for this alarm.
    In the command ZYEI there
    UNIT FUNCTIONAL FRAME ALIGNMENT SA-BITS FOR
    MODE MODE Q.1 USE

    ET-32 NORM DBLF – V3 SPV OFF
    ET-33 NORM CRC4 – V3 SPV OFF

    #40731
    Mohammad Yasin
    Guest

    Hi Patrick
    Can you explain a little more on what you have done for this alarm.
    In the command ZYEI there
    UNIT FUNCTIONAL FRAME ALIGNMENT SA-BITS FOR
    MODE MODE Q.1 USE

    ET-32 NORM DBLF – V3 SPV OFF
    ET-33 NORM CRC4 – V3 SPV OFF

    I wanted a little more explanation on where to keep CRC4 or DBLF mode

Viewing 4 posts - 1 through 4 (of 4 total)
  • The forum ‘Telecom Design’ is closed to new topics and replies.