Hi Pix,
thank you very much for your support. I got a lot situations where the quality was like this 0-0-0-0-0-0-0-0-7-7-handover-0-0 (values of RXQUAL sub).
However, when I use the RXQUAL_full values (which I have to if DTX DL is disabled), the values are, e.g. 2-3-2-1-handover-2-2-2-0-0 which I can explain.
The handover command came before the bad RXQUAL values. I don’t know why I haven’t had a look at this earlier…
It seems that my evaluation software or the phone does soem strange things since the serving cell changes tree measurement reports after the HANDOVER COMPLETE message.
Unfortunately, I have to rely on a “normal” phone. Thus, I cannot provide any BERs.
Thank you very much again! I just wanted to make sure that I don’t have any wrong ideas.
/Hendrik