Generic selectors
Exact matches only
Search in title
Search in content
Post Type Selectors

Reply To: signaling link – full duplex

#53759
pix
Guest

as stated in wikipedia:

“An E1 link operates over two separate sets of wires, usually twisted pair cable. A nominal 3 Volt peak signal is encoded with pulses using a method that avoids long periods without polarity changes. The line data rate is 2.048 Mbit/s (full duplex, i.e. 2.048 Mbit/s downstream and 2.048 Mbit/s upstream) which is split into 32 timeslots, each being allocated 8 bits in turn. Thus each timeslot sends and receives an 8-bit sample 8000 times per second (8 x 8000 x 32 = 2,048,000). This is ideal for voice telephone calls where the voice is sampled into an 8 bit number at that data rate and reconstructed at the other end. The timeslots are numbered from 0 to 31.”

whether it’s speech, data or signalling it’s always the same principle. This is layer-1, it doesn’t care what is being transported…