5th September 2015 at 19:53
#43990
Muhammad Bilal
Guest
my problem is
“Power limits exceeded”
when recreat IDB the problem deplace between SA, SB SC
all these action
Check the TX cable between the TRU and the CDU-F/CU.
• Switch OFF and ON the power to the CDU-F/CU.
• Reset the TRU.
• Replace the CDU-F/CU.
• Replace the TRU.
Otherwise:
• Check the TX cable between the TRU and the CDU.
• Check the Pfwd and Prefl cables (if present) between the TRU and
CDU/CU.
• Check the TX cables/feeders and connections inside and outside the
cabinet.
• Switch OFF and ON the power to the CDU/F