9th June 2010 at 03:31
#41980
Paul
Guest
Dear Pix,
So, based on your statement (TSC is not used when the MS measures the neighbor cells. It is only used on the dedicated channel), what signaling is used for Handover? this should be BCCH right? Then, How does the MS listen/know the BCCH of the neighboring cell without Training Sequence? Then, how about re-selection?
From Mania’s statements, TSC is also sent in the Assignment Command and the Handover Command to syncrhonize. So, I’m a little bit confused about it.
Could you explain it again Pix?
Thanks A lot.
Paul