7th January 2005 at 11:50
#40455
Soni
Guest
Hello Rajesh
I have tried all ANR** commands (except ANRSP) and I have received the same fault code:
“CHANGE IN NON-OPERATING AREA IS IN PROGRESS”
I know how this problem occured.
I think are used only these two commands.
ANRZI:RC=xx;
ANRPI:RC=xx;
This way I can not zero a RC, because the procedure is not closed. I cann’t close the procedure because no changes are specified (ANRSI command).
I want to know:How to find out the RC for which the procedure is not finished?
Thank you