Hello,
sorry I had written.
I have connected two E1s each other. (e1 3/0 to e1 3/1). I want to make Ip to Ip connection.
E1s are up, they seem normally..
pin connections are.
E1: 1 2 4 5
E1: 4 5 1 2
I have made config but the reason is no route to destination..
Thanks
ismail can
Controller E1 3/0
pri-group timeslots 1-31
!
controller E1 3/1
pri-group timeslots 1-31
interface Serial3/0:15
no ip address
ip mroute-cache
isdn switch-type primary-qsig
isdn overlap-receiving
isdn protocol-emulate network
isdn incoming-voice modem
no cdp enable
!
interface Serial3/1:15
no ip address
ip mroute-cache
isdn switch-type primary-qsig
isdn incoming-voice modem
fair-queue 64 256 0
no cdp enable
voice-port 3/0:D
input gain 6
echo-cancel coverage 16
cptone TR
timeouts interdigit 5
timeouts ringing infinity
bearer-cap Speech
!
voice-port 3/1:D
input gain 6
echo-cancel coverage 16
cptone TR
timeouts interdigit 5
timeouts ringing infinity
bearer-cap Speech
dial-peer voice 97 pots
huntstop
destination-pattern 40T
direct-inward-dial
port 3/0:D
!
dial-peer voice 98 pots
huntstop
incoming called-number .T
port 3/1:D
!
dial-peer voice 6666 voip
huntstop
destination-pattern 40T
session target ipv4:a.b.c.d