28th June 2004 at 20:58
#27510
Mark
Guest
Saleh,
Unfortunately no such command exists. If you are having a problem with the line disconnecting, most likely this is due to an incorrect configuration for disconnect supervision. You may want to try to configure the unit for disconnect tone (config pstntg 1# supervision 1) and make sure that the cassignaling is set to loop start only.
You may want to review the document on Quintum’s Web site that discusses disconnect supervision. It can be found at;
http://www.quintum.com/support/1G/kb/telco/Disconnect_Supervision.pdf