Free Erlang traffic calculators

The world's first online Erlang traffic calculators

Telecom Traffic Online
  Home | Free calculators | Products | Tech. papers | Forum | About us
A-Z termination - click here
A-Z termination - CLICK HERE
VoIP bandwidth calculator
  • VoIP softswitch

    DUAL Softswitch is a complete Voice over IP switching and billing solution.  Flat monthly rate.

    Web control panels; Least Cost Routing; Excel tariff uploads; SIP and H323 support.

    H323 SIP softswitch >>

  • VoIP calling

    Premium quality termination for wholesale carriers with their own VoIP switch.

    44Direct >>


    Our lowest rates for wholesale carriers with their own VoIP switch.

    44Mobile >>


    Our unique online callshop billing system.

    Bill My Calls >>

Alcatel A9100 BTS

Mer - 19th March 2019  (09:30 GMT)

Hi anuj

hhhh, yes more than 10 years :)

the Whole region was swapped from ALU to Huawei

BR.

anuj - 19th September 2018  (16:57 GMT)

its been 10 year did anyone find the solution of it?

Mer - 27th April 2008  (09:01 GMT)

Hi

in our side, we don't find a solution or an explanation to this problem but we note some thing:
after we make an offline commissioning, the problem return to the initial state (the famous TRE 9).

pix - 25th April 2008  (18:59 GMT)

bts cabinet inner cabling, possibly ? it looks like you have changed everything inside the BTS, so maybe the BTS cabinet is faulty.

Have you tried to delete the cell, and recreate it from scratch ? Re-homing it to another TSU/TCU ?

I don't know... just suggesting.. you can also contact your regional support.

Shahnawaz - 25th April 2008  (07:58 GMT)

Hi
in fact we are also facing the same problem, TRE5 of SectorGSM C,after lock/unlock TRE got busy but after some time it went down again
what we have done so far is:
-changed the TRE
-changed the CSO3 cable
-changed the port of the ANC
-changed the slot of TRE
-done the offline comissioning of SUMA
what next? please suggest if im missing some thing....

pix - 18th August 2007  (17:11 GMT)

normally, this is an ANC failure... have you tried swapping TRX with another one ? The faulty TRX is the same, or is it the new TRX becoming faulty ?
I would exchange the ANC by another one again, from sector 1 or sector 2, since they are working.

You could also try changing the SUM card... and eventually, change the whole BTS :)

aristotle - 18th August 2007  (11:23 GMT)

Hi mer,
you may need to reset the BTS to refresh the SW. However, you have not mentioned if you performed sweep test with site master. Try to check this as well.

Mer - 16th July 2007  (14:22 GMT)

Hi,

I have a problem in an Alcatel BTS A9100 (indoor GSM 4+4+4), the problem is located in sector 3 with 4 TRX (X polarisation antenna:+45,-45),always there is one TRX down with this message(alarm 10 class 10 in BTS Terminal):
TRE-VSWR:a fault has been detected by the VSWR supervision on the TRE output during initialization or operation states...
the TRX is changed, the combiner is changed,the cable between TRX and combiner is also changed (VSWR of sector:1.1 1.1), this problem affect one,two or three TRX in the same time, now three TRX work and one is locked.

thanks for all

Post a reply to this article

Name Enter your name.
Message Enter your message.
Email Optional -  If you enter your email address in this box, then you will automatically be notified if anyone replies to your message.  Your email address will only be published if you pay to post this message.
Verification
Please confirm you are human.
Press the button to post your message.
Home | Free online calculators | Products | Technical papers | Forum | Contact us | About us

Last modified: 17 May 2017

Copyright 2017. All rights reserved.